DaimlerChrysler LH New Yorker 1994, Электронное руководство по обслуживанию

Страница: 278 / 1203

(11) Loosen the adjustment nut. Allow the cable to
adjust itself to the correct position. Tighten the ad-
justment nut.
(12) Check the interlock adjustment:
•
With the ignition key in the OFF (lock) position,
the shifter should be locked in the PARK position. If
not, re-adjust the interlock and tighten the adjust-
ment nut (Fig. 15).
•
Without starting the engine,place the ignition
switch in the run position. Move the shifter to the
reverse position. You should not be able to remove the
ignition key from the lock cylinder. If the key can be
removed at this point, re-adjust the interlock and
tighten the adjustment nut (Fig. 15).
•
Place the shifter in the PARK position. Turn the
ignition key to the OFF (lock) position. You should be
able to remove the ignition key from the lock cylinder.
If not, re-adjust the interlock and tighten the adjust-
ment nut (Fig. 15).
(13) Install the bezel on the shifter console.
(14) Install shifter handle column.
LOCK CYLINDER HOUSING
The lock cylinder housing attaches to the steering
column with tamper-proof screws and hardened
washers (Fig. 16).
REMOVAL
(1) Remove the tilt lever attaching screw. Remove
lever.
(2) Remove the upper and lower covers from the
steering column.
(3) If the vehicle has floor shift, remove the inter-
lock cable. If the vehicle has column shift, remove and
discard the column shift interlock cassette.
(4) Remove the multi-function switch and ignition
switch. Refer to Ignition Switch in this section.
(5) Center punch the tamper-proof screws.
(6) Using a 6 mm (1/4 inch) drill bit, drill out the
screw heads. Drill until the bit contacts the hardened
washer under the screw head.
(7) Remove the lock cylinder housing from the
steering column.
(8) Use a pair of pliers to remove the bolts from the
lock steering column.
INSTALLATION
The heads of the tamper-proof mounting screws
shear off when tightened.
(1) Position lock cylinder housing on steering col-
umn.
(2) Tighten new mounting screws until the heads of
the tamper-proof screws shear off.
(3) Install ignition switch and multi-function
switch.
(4) If the vehicle has column shift, install a new
column shift interlock cassette. If the vehicle has a
floor shift, reconnect and adjust the shift cable.
(5) Install upper and lower covers on steering col-
umn.
(6) Install tilt lever
Fig. 16 Lock Cylinder Housing Mounting Screws
IGNITION SYSTEMS 8D - 21