Daily Youth GT5Ds, Руководство пользователя

Страница: 18 / 19

-17-
Fault or phenomenon Possible reasons Handling method
No display of the treadmill
A. power is not plugged or there is
no power supply.
Plug the power lines into the AC current, or
check the AC socket
B. The power switch is not on. Switch the power to “ON”
C. The driver is not-powered or has
been damaged.
Replug the drive power cord or replace the
drive
D. Disconnection of the Electronic
meter signal lines.
Replace the signal lines and plug the lines
again
E. The Electronic meter is damaged Replace Electronic meter
The treadmill is displayed incompletely
and lack of strokes
A. Insufficient welding or
connecting welding of drive IC is
displayed
It is required to carry out repair, check the
welds and weld them in place again.
B. Bus bar slides and isn’t fixed in
place
Reassemble bus bar
C. Bad drive IC is displayed
It is required to carry out repair and weld
new display drive IC
The operation of the treadmill is not
smooth, shaking or without force.
A. There is resistance in the
transmission parts
Adjust the transmission parts or add
lubrication oil
B. The transmission belt is over
tight or over loose
Adjust the tightness of the transmission belt
C. The torque of the drive is over
little or over large
Adjust the torque potentiometer to the
proper position
Display of
the
Electronic
meter
---or----
A. The safety lock fell off
Put the safety lock onto the plate for the
actuation or the card inserting position
B. The magnetron is not connected
properly
Install the magnetron into the right position
E01- communication fault
(the Electronic meter signal
cannot be received by the
drive);
E13- communication fault
(the drive signal cannot be
received by the Electronic
meter)
A .The signal lines of the electronic
meter is not well plugged or poor
connection
Plug the lines again
B. The signal lines are damaged or
there is short circuit or open circuit
Replace the signal lines
C. Line fault of the electronic meter
signal
Replace the electronic meter
D. Line fault of the drive Replace the drive
E02- stalling protection
(explosion-proof protection
or the major motor is
abnormal)
A. The motor lines are not well
connected or the motor inside is
open circuit
Plug the motor line again or replace the
motor
B. The puncture and damage of the
drive IGBT
Replace the drive
C. The voltage of the outside AC
current is too low
Stop using and let the electrician eliminate
the fault
E04- hoisting self-checking
learning failure(with hoisting
drive)
A. The motor lines of the motor or
the signal lines are not well plugged
Check whether the lines are wrong
connected or not, plug the lines again
B. Bad hoisting motor Replace hoisting motor
C. Bad drive Replace the drive
E05- overcurrent protection
A. Overload
Systematic protection, restart if there is
man-made lock
B. The transmission parts are stuck
or impeded
Adjust the transmission parts or add
lubrication oil
C. The motor inside is short circuit Replace the motor
D. Burnout of the drive Replace the drive
E06- it is usually open
circuit of motor
A. The motor lines are not well
plugged
Plug the motor line again
B. The motor inside is open circuit Replace the motor
C. Motor idling
Please install the treadmill and test it due to
the error when the current is over little
E08- storage 24C02 error
A. Storage IC is not plugged in Reconnect IC socket and pay attention to