-13-
6.Power saving mode:
This system has power saving function. If there is no key command input within 10 minutes in
standby state, the system enters power saving mode, automatically turns off the display, and presses
any key to wake up the system again.
7.MP3 function:
When MP3 or other audio equipment is connected after power is applied, the electronic watch can
play music. The volume control of sound is on the audio equipment, please pay attention to control the
volume of sound so as not to affect the quality of sound and the built-in audio circuit.
8.Shut down:
The treadmill can be off by turn off the power or the treadmill at any time, which does not damage it.
9.Precautions:
9.1 Check whether the power supply is loaded before the movement; Check whether the safety lock
is valid.
9.2 Whether there are abnormal conditions or not during sporting; the treadmill may quickly slow down
until to stop by pulling off the safety lock; put the safety lock in the place again and reset the
equipment waiting for entering order.
9.3 If you have any questions about the treadmill, please contact the distributor. It is not allowed for
laymen to disassemble or maintain the treadmill for fear of damaging the treadmill.
VII. Use method and safety protection for treadmill
1. Debugging of treadmill
1.1 After the installation is completed, position the safety lock to the corresponding position of electronic
meter.
1.2 Before the powering, inspect whether the power ground wire is well grounded and pull the running
belt with hands to check whether it can run flexibly without any abnormal sound.
1.3 Plug in the power supply and open the power supply lock. Then, all windows on the electronic meter
show the initial values and the running belt is still.
1.4 Press the “Start” Key and the treadmill starts operating at a low speed (the operating speed is
1km/h). Observe whether the treadmill and electronic meter can operate normally.
1.5 Press the “Speed-up” Key and “Speed-down” Key to observe whether the regulation is normal.
1.6 Press the “Stop” Key or pull in the safety lock, and the treadmill may stop operating. Turn off the
power switch and unplug the power supply.
2. Operating instructions
After being debugged, the electric treadmill can be put into use
2.1 Plug the power supply in the household 220V outlet. The outlet must be provided with appropriate
grounding wire.
2.2 Emplace the safety lock and press “Start” Key, and then the running belt may operate slowly (the
speed is about 1km/h). The speed per hour is displayed on the meter.
2.3 If the treadmill needs to be accelerated, press the “Speed-up” Key and the buzzer’s “tick” indicates
one level up. The maximum speed per hour is 18km/h.
2.4 If you cannot wait for the deceleration while running on the treadmill at a high speed, you can pull
out the safety lock and the treadmill may immediately stop.
2.5 Press “STOP” after running and the treadmill slows down until it stops.
Содержание GT5Ds
Страница 1: ...GT5Ds DC Commercial Motorized Treadmill...
