Daikin homecontrols EKRCTRDI2BA, Инструкция по установке и эксплуатации

Страница: 28 / 40

28
Replacing batteries Troubleshooting
8 Replacing batteries
If the symbol for empty batteries ( ) appears, replace the
used batteries by two new LR6/mignon/AA batteries. You
must observe the correct battery polarity.
To replace the batteries of the accessory, proceed as fol-
lows:
1. Once mounted, the electronic unit (A) can easily
be pulled out of the wall mounting plate. Grab the
sides of the electronic unit and pull it from the wall
mounting plate.
2. Turn the electronic unit over to replace the batte-
ries.
3. Insert two new 1.5 V LR6/mignon/AA batteries.
Make sure that you insert them the right way round
(see figure 12) .
4. Place the electronic unit back into the wall moun-
ting plate (see figure 10) .
5. Pay attention to the flashing signals of the LED
while inserting the batteries (see „9.3 Error codes
and flashing sequences“ on page 31).
After inserting the batteries, the accessory will perform a
self-test (approx. 2 seconds). Afterwards, initialisation is
carried out. The LED will light up orange and green to indi-
cate that initialisation is complete.
Attention! There is a risk of explosion if the battery
is not replaced correctly. Replace only with the
same or equivalent type. Never recharge non-
rechargeable batteries. Do not throw the batteries
into a fire. Do not expose batteries to excessive
heat. Do not short-circuit batteries. Doing so will
present a risk of explosion.
Used batteries should not be disposed of with reg-
ular domestic waste! Instead, take them to your lo-
cal battery disposal point.
9 Troubleshooting
9.1 Weak battery
Provided that the voltage value permits it, the accessory
will remain ready for operation even if the battery voltage
is low. Depending on the particular load, it may be possible
to send transmissions again repeatedly, once the batteries
have been allowed a brief recovery period.
If the voltage drops too far during transmission, the empty
battery symbol ( ) and the corresponding error code will
be displayed on the accessory (see “9.3 Error codes and
flashing sequences” on page 31). In this case, replace
the empty batteries by two new batteries (see “8 Replacing
batteries” on page 28).