English
2
•
Securely fasten the outside unit terminal cover (panel). If
the terminal cover/panel is not installed properly, dust or
water may enter the outside unit causing fire or electric
shock.
•
When installing or relocating the system, keep the refrig-
erant circuit free from substances other than the speci-
fied refrigerant (R-410A) such as air. Any presence of air
or other foreign substance in the refrigerant circuit can
cause an abnormal pressure rise or rupture, resulting in
injury.
•
Do not change the setting of the protection devices. If
the pressure switch, thermal switch, or other protection
device is shorted and operated forcibly, or parts other
than those specified by Daikin are used, fire or explosion
may occur.
CAUTION
•
Do not touch the switch with wet fingers. Touching a
switch with wet fingers can cause electric shock.
•
Do not allow children to play on or around the unit to pre-
vent injury.
•
Do not touch the refrigerant pipes during and immedi-
ately after operation as the refrigerant pipes may be hot
or cold, depending on the condition of the refrigerant
flowing through the refrigerant piping, compressor, and
other refrigerant cycle parts. Your hands may suffer
burns or frostbite if you touch the refrigerant pipes. To
avoid injury, give the pipes time to return to normal tem-
perature or, if you must touch them, be sure to wear
proper gloves.
•
Heat exchanger fins are sharp enough to cut.
To avoid injury wear glove or cover the fins when work-
ing around them.
•
Install drain piping to proper drainage. Improper drain
piping may result in water leakage and property damage.
•
Insulate piping to prevent condensation.
•
Be careful when transporting the product.
•
Do not turn off the power immediately after stopping op-
eration. Always wait for at least 5 minutes before turning
off the power. Otherwise, water leakage may occur.
•
Do not use a charging cylinder. Using a charging cylin-
der may cause the refrigerant to deteriorate.
•
Refrigerant R-410A in the system must be kept clean,
dry, and tight.
(a)Clean and Dry -- Foreign materials (including mineral
oils such as SUNISO oil or moisture) should be pre-
vented from getting into the system.
(b)Tight -- R-410A does not contain any chlorine, does
not destroy the ozone layer, and does not reduce the
earth’s protection again harmful ultraviolet radiation.
R-410A can contribute to the greenhouse effect if it is
released. Therefore take proper measures to check
for the tightness of the refrigerant piping installation.
Read the chapter Refrigerant Piping and follow the
procedures.
•
Since R-410A is a blend, the required additional refriger-
ant must be charged in its liquid state. If the refrigerant
is charged in a state of gas, its composition can change
and the system will not work properly.
•
The indoor unit is for R-410A. See the catalog for indoor
models that can be connected. Normal operation is not
possible when connected to other units.
•
Remote controller (wireless kit) transmitting distance
can be shorter than expected in rooms with electronic
fluorescent lamps (inverter or rapid start types). Install
the indoor unit far away from fluorescent lamps as much
as possible.
•
Indoor units are for indoor installation only. Outdoor
units can be installed either outdoors or indoors.
•
Do not install the air conditioner in the following loca-
tions:
(a)Where a mineral oil mist or oil spray or vapor is pro-
duced, for example, in a kitchen.
Plastic parts may deteriorate and fall off or result in
water leakage.
(b)Where corrosive gas, such as sulfurous acid gas, is
produced.
Corroding copper pipes or soldered parts may result
in refrigerant leakage.
(c)Near machinery emitting electromagnetic waves.
Electromagnetic waves may disturb the operation of
the control system and cause the unit to malfunction.
(d)Where flammable gas may leak, where there is carbon
fiber, or ignitable dust suspension in the air, or where
volatile flammables such as thinner or gasoline are
handled. Operating the unit in such conditions can
cause a fire.
•
Take adequate measures to prevent the outside unit
from being used as a shelter by small animals. Small ani-
mals making contact with electrical parts can cause mal-
functions, smoke, or fire. Instruct the customer to keep
the area around the unit clean.
NOTE
•
Install the power supply and control wires for the indoor
and outdoor units at least 3.5 feet away from televisions
or radios to prevent image interference or noise.
Depending on the radio waves, a distance of 3.5 feet may
not be sufficient to eliminate the noise.
•
Dismantling the unit, treatment of the refrigerant, oil and
additional parts must be done in accordance with the rel-
evant local, state, and national regulations.
•
Do not use the following tools that are used with conven-
tional refrigerants: gauge manifold, charge hose, gas
leak detector, reverse flow check valve, refrigerant
charge base, vacuum gauge, or refrigerant recovery
equipment.
•
If the conventional refrigerant and refrigerator oil are
mixed in R-410A, the refrigerant may deteriorate.
•
This air conditioner is an appliance that should not be
accessible to the general public.
•
The wall thickness of field-installed pipes should be
selected in accordance with the relevant local, state, and
national regulations.
01_EN_3P086156-13Y.fm Page 2 Wednesday, September 16, 2009 2:22 PM
