7
English
(3) Remove the parts of the indoor unit.
1)
Remove the suction grille.
•
Slide the suction grille fixing knobs (32 type: 2 places for each, 63, 100 type: 3 places for each)
toward backward direction (as shown by an arrow) to open the suction grille widely.
(Refer to Fig. 4)
•
Keeping the suction grille opened, hold the knob at the back of the suction grille and at the same
time, pull the suction grille forward to remove.
(Refer to Fig. 5)
2)
Remove the decoration side panel (right, left).
•
Remove the fixture screw of the decoration
side panel (one for each), pull forward (arrow
direction) to remove.
(Refer to Fig. 6)
•
Take out accessories.
(Refer to Fig. 6)
•
Open the knock hole at the wiring inlet side at
the rear surface or top surface, and install the
attached resin bushing (10).
3)
Remove the hanger.
•
Loosen 2 bolts for installing the hanger at both sides (M8) (4 places at left and right) within 10mm.
(Refer to Fig. 7 and 8)
•
Remove the fixture screw for hanger at the back side (M5), pull the hanger backward (the arrow
direction) to remove.
(Refer to Fig. 8)
CAUTION
Do not remove the tape (milky white) applied to the outside of the indoor unit. It may cause electric shocks
or a fire.
Fixing knob
Suction
grille
Fig. 4
Rear knob
Fig. 5
Decoration side panel
Accessories
Fixing screw for
decoration side panel
(M4)
Fig. 6
Resin bushing (10)
(accessory)
Resin bushing (10)
(accessory)
Removable part (for leading
in from the top-surface)
Removable part (for leading
in from the rear-face)
Hanger fixing screw (M5)
Hanger installing
bolt (M8)
Hanger
Loosen
Bolt (M8)
Loosen within10mm
Indoor unit
Hanger
Fig. 7
Fig. 8
01_EN_3P249378-8N.fm Page 7 Saturday, September 29, 2012 3:02 PM