Daikin FTXTA30A2V1BW, Руководство по установке для специалистов, Страница: 12 / 24

6 Installation
Installer reference guide
12
FTXTA30A2V1BW
Split system air conditioner
4P518023-6E – 2019.04
b
a
a Hook
b Flat screwdriver
6.2.6 To re-install the front grille
1 Install the front grille and firmly engage the 3 upper hooks.
2 Tighten the 2 screws and put the 2 screw covers back.
3 Re-install the flap.
4 Insert the wire harness back into the connector and secure it
with the wire clamp.
5 Close the front panel. Refer to "6.2.2 To close the front
panel" on page 10 .
6.2.7 To remove the electrical wiring box cover
1 Remove the front grille.
2 Remove 1 screw from the electrical wiring box.
3 Open the electrical wiring box cover by pulling it to the front.
4 Remove the electrical wiring box cover from the 2 rear hooks.
1
2
b
a
c
c
a Screw
b Electrical wiring box
c Rear hook
5 To re-install the cover, first attach the electrical wiring box to the
hooks, close the electrical wiring box, and re-install the screw.
NOTICE
When closing the electrical wiring box cover, make sure
that
the tightening torque does NOT exceed
2.0 (±0.2) N•m.
6.3 Installing the indoor unit
6.3.1 Precautions when installing the indoor
unit
INFORMATION
Also read the precautions and requirements in the
following chapters:
▪ General safety precautions
▪ Preparation
6.3.2 To install the mounting plate
1 Install the mounting plate temporarily.
2 Level the mounting plate.
3 Mark the centres of the drilling points on the wall using a tape
measure. Position the end of tape measure at symbol " ".
4 Finish the installation by securing the mounting plate on the wall
using M4×25L screws (field supply).
INFORMATION
The removed pipe port cover can be kept in the mounting
plate pocket.