9
Preparation Before Operation
To insert the batteries
Position and
correctly!
+
–
2
3
1
Slide the front cover to take it off.
1.
Insert 2 dry batteries AAA.LR03 (alkaline).
2.
Replace the front cover.
3.
To
fi
x the remote controller holder to a wall
Remote
controller holder
Remote controller
Screws
Choose a place from where the signals
1.
reach the unit.
Fix the holder to a wall, a pillar, or similar
2.
location with the screws supplied with the
holder.
Place the remote controller in the remote
3.
controller holder.
To set the luminance of the display
The luminance of the indoor unit display can be set.
•
Press
.
Hi
Low
Off
NOTE
Notes on batteries
When replacing the batteries, use batteries of the same type, and replace both old batteries together.
•
When the system is not used for a long time, take the batteries out.
•
The batteries will last for about 1 year. If the remote controller display begins to fade and the possible transmission range becomes shorter
•
within a year, however, replace both batteries with new, size AAA.LR03 (alkaline).
The batteries supplied with the remote controller are for initial operation.
•
The batteries may run out in less than 1 year.
Notes on remote controller
Never expose the remote controller to direct sunlight.
•
Dust on the signal transmitter or receiver will reduce the sensitivity. Wipe off dust with soft cloth.
•
Signal communication may be disabled if an electronic-starter-type
fl
uorescent lamp (such as inverter-type lamps) is in the room. Consult
•
the shop if that is the case.
If the remote controller signals happen to operate another appliance, move that appliance to somewhere else, or consult the service shop.
•
01_EN_3P369488-1.indd 9
01_EN_3P369488-1.indd 9
6/11/2014 10:58:51 AM
6/11/2014 10:58:51 AM
