Daikin ETSHB16P30EF, Руководство по установке для специалистов

Страница: 171 / 308

10 | Configuration
Installer reference guide
171
EPRA14~W1 + ETSH/X(B)16P30+50EF
Daikin Altherma 3 H HT ECH₂O
4P679467-1 – 2022.02
# Code Description
[2.6] [1-06]
[1-07]
[1-08]
[1-09]
Set weather-dependent cooling in [2.6] Cooling
WD curve :
[1-09]
[1-08]
Ta
Tt
[1-06] [1-07]
T
t
Target leaving water temperature (main zone)
T
a
Outdoor temperature
Set weather-dependent heating in [9.l]
Overview field settings :
▪ [1-06]: Low outdoor ambient temperature.
10°C~25°C
▪ [1-07]: High outdoor ambient temperature.
25°C~43°C
▪ [1-08]: Desired leaving water temperature
when the outdoor temperature equals or drops
below
the low ambient temperature.
[9‑03]°C~[9‑02]°C
Note: This value should be higher than [1‑09]
as for low outdoor temperatures less cold
water is required.
▪ [1-09]: Desired leaving water temperature
when the outdoor temperature equals or rises
above
the high ambient temperature.
[9‑03]°C~[9-02]°C
Note: This value should be lower than [1‑08] as
for high outdoor temperatures colder water is
required.
Emitter type
Heating up or cooling down the main zone can take longer. This depends on:
▪ The water volume of the system
▪ The heater emitter type of the main zone
The setting Emitter type can compensate for a slow or a quick heating/cooling
system during the heat up/cool down cycle. In room thermostat control, Emitter
type influences the maximum modulation of the desired leaving water
temperature, and the possibility for usage of the automatic cooling/heating
changeover based on the indoor ambient temperature.
It is important to set Emitter type correctly and in accordance with your system
layout. The target delta T for the main zone depends on it.