Daikin EGSQH10S18AA9W, Руководство по установке

Страница: 5 / 28

4 Installation
Installation manual
5
EGSQH10S18AA9W
Daikin Altherma ground source heat pump
4P351747-1F – 2016.06
3.3 Preparing electrical wiring
3.3.1 Overview of electrical connections for
external and internal actuators
Item Description Wires Maximum
running
current
Indoor unit power supply
1 Power supply for E1
and E3 3+N + GND
(a)
2 Power supply for E2 2
(c)
4 Preferential kWh rate
power supply (voltage
free contact) 2
(d)
5 Normal kWh rate power
supply 2 6.3 A
User interface
6 User interface 2
(e)
Optional equipment
12 Room thermostat 3 or 4 100 mA
(b)
13 Outdoor ambient
temperature sensor 2 (b)
14 Indoor ambient
temperature sensor 2
(b)
15 Heat pump convector 4 100 mA (b)
Field supplied components
16 Shut-off valve 2 100 mA
(b)
17 Electricity meter 2 (per meter)
(b)
18 Domestic hot water
pump 2
(b)
19 Alarm output 2
(b)
20 Changeover to external
heat source control 2
(b)
22 Power consumption
digital inputs 2 (per input
signal)
(b)
23 Safety thermostat 2
(d)
(a) Refer to name plate on unit.
(b) Minimum cable section 0.75 mm².
(c) Cable section 2.5 mm².
(d) Cable section 0.75 mm² till 1.25 mm²; maximum length:
50 m. Voltage-free contact shall ensure the minimum
applicable load of 15 V DC, 10 mA.
(e) Cable section 0.75 mm² till 1.25 mm²; maximum length:
500 m. Applicable for both single user interface and dual
use interface connection.
NOTICE
More technical specifications of the different connections
are indicated on the inside of the indoor unit.
4 Installation
4.1 Opening the units
4.1.1 To open the indoor unit
1 Loosen and remove the screws at the bottom of the unit.
2 Push on the button at the bottom of the front plate.
WARNING: Sharp edges
Take the front plate on the upper part instead of the lower
part. Watch your fingers, there are sharp edges on the
lower part of the front plate.
3 Slide the front panel of the unit downwards and remove it.
CAUTION
The front panel is heavy. Be careful NOT to jam your
fingers when opening or closing the unit.
4 Loosen and remove the 4 screws that fix the top panel.
5 Remove the top panel from the unit.
4×
2×
3
2
4
5
1
2
4.1.2 To open the switch box cover of the
indoor unit
7×