English
10
2)
Make sure to connect the connector of the swing motor lead wiring to the connector on the Printed Cir-
cuit Board (A1P) inside of the indoor unit control box.
(Refer to Fig. 22)
3)
After finishing wiring, close the resin cover as it was. (Clamps are not needed.)
(Refer to Fig. 21)
5. INSTALLATION OF SERVICE COVER (CONTROL BOX) AND AIR FILTER
(1)
Attach the service cover (control box).
(Refer to Fig. 23)
After hooking the front tab, tighten by the screw.
(Refer to Fig. 24)
(2)
Hook the part of air filter to the tab of the decoration panel.
(Refer to Fig. 25)
Wire saddle
Let the lead wiring
into the wire saddle.
Swing motor lead wiring
Let the connector of the
lead wiring into the control
box lid and the control box.
Printed Circuit Board (A1P)
Connector (X36A)
2)
Connect firmly
Control box lid
Fig. 22
Fig. 23
Screw
Service cover
Front tab
Fig. 24
Service cover (conrtol box)
Screw
01_EN_3P328940-1.fm Page 10 Monday, September 24, 2012 10:00 AM
