9
English
2)
Make sure to connect the connector of the swing motor lead wiring to the connector on the Printed Cir-
cuit Board (A1P) inside of the indoor unit control box.
(Refer to Fig. 20)
〈〈
CAUTION
〉〉
Swing blade will not operate without connecting the connector.
3)
Install the control box lid of the indoor unit in a reverse order of the procedure at
1)
.
(Refer to Fig. 19)
CAUTION
Do not have the swing motor lead wiring get caught in the control box lid.
〈〈
If only the decoration panel is installed later
〉〉
1)
Cut off the clamp and open the resin cover.
(Refer to Fig. 21)
Swing motor Lead
wiring
Fig. 20
The direction of indoor unit here
is different from actual one.
(This is only for explanation)
Wire saddles
Let the lead wiring
into wire saddle.
Swing motor
lead wiring
Connector
(X36A)
2)
Connect
firmly.
Printed Circuit Board
(A1P)
Control box
1)
Open the resin cover
Resin cover
1)
Cut off clamp
Fig. 21
01_EN_3P328940-1.fm Page 9 Monday, September 24, 2012 10:00 AM
