English
16
Press OPERATION MODE SELECTOR
BUTTON
“
” on the right-hand of the malfunction
code blinks.
Press PROGRAMMING TIMER BUT-
TON and change the malfunction code.
Press until the indoor unit makes a long
beep.
The malfunction code is fixed when the
indoor unit makes a long beep.
Reset of the display
Press OPERATION MODE SELECTOR
BUTTON to get the display back to the
normal state.
5
MODE
6
DOWN
UP
7
MODE
UNIT N
O
.
CODE
MODE
TIMER
RESERVE CANCEL
DOWN
UP
/TEST
SWING
FAN
TIME
TEMP
1
2 4
6
3 5
7
ON OFF
2 4
6
II.
IN CASE BESIDES EMERGENCY STOP
1. The unit does not operate at all.
•
Check if the receiver is exposed of
sunlight or strong light. Keep receiver
away from light.
•
Check if there are batteries in the
remote controller. Place the batteries.
•
Check if the indoor unit number and
wireless remote controller number are
equal.
Operate the indoor unit with the remote con-
troller of the same number.
Signal transmitted from a remote controller of
a different number cannot be accepted. (If
the number is not mentioned, it is considered
as “1”)
2. The system operates but it does not
sufficiently cool or heat.
•
If the set temperature is not proper.
(Refer to page 10)
•
If the FAN SPEED is set to LOW
SPEED. (Refer to page 10)
•
If the airflow angle is not proper. (Refer
to page 11)
If the problem is not solved after checking the
above points, please do not try to repair it
yourself. In such cases, always consult your
local dealer. At this time, please tell the
symptom and model name (written on the
manufacturer’s label).
Number
Number
01_EN_3P302565-1.fm Page 16 Monday, February 13, 2012 4:09 PM