Daikin Altherma EKRTCTRL1, Руководство по установке

Страница: 10 / 24

10
S I U
H4
8mm 0.2-1.5mm
2
EKWHCTRL0
A
3.3 EKWHCTRL0 connections
-AB+
serial connection for wall-mounted remote
control EKWHCTRL1 (respect AB polarity)
H2** hot water temperature probe (10 kΩ)
M1
DC inverter fan motor
S1
grill safety micro-switch
Y1
hot water solenoid valve (230V/ 50Hz 1A output
voltage)
Y2
mobile flap
(230V/ 50Hz 1A output voltage)
L-N
230V/50Hz electrical power supply
BO
boiler consent output (free contact max 1A)
CH chiller consent output (free contact max 1A)
CP
not used in this version
AIR Air probe optional (*)
*
Alternatively, connect the wall-mounted
controller EKWHCTRL1 to the air probe
**
If after switching the power on the board
detects the H2 probe, start-up occurs in normal
conditions with the minimum water temperature
when heating (30°C) and maximum when
cooling (20°C).
The board also has a function when there is no
probe, in such cases the fan stop minimum and
maximum thresholds are ignored.
Rigid or flexible wires with a 0.2 to 1.5 mm² cross-section
(0.75 mm² if two wires are connected to the same terminal
block) can be inserted in the 4 spring-loaded terminal
blocks (ref. A) for connection of the wall-mounted controller
EKWHCTRL1. If the wires have wire end ferrules with a
plastic collar, the maximum cross-section is 0.75 mm². Strip 8 mm of the wire, then if the wire is rigid, you can
insert it easily whereas, if it is flexible, it is advisable to use
long nose pliers.
Push the wire completely in and check that it is anchored
by pulling it gently.
To disconnect the cables, press the
corresponding white indent (ref. A) with a
screwdriver and remove the conductor.