Daikin Altherma 3 M Series, Руководство по эксплуатации

Страница: 5 / 24

4 Quick guide
Operation manual
5
EBLA09~16DA + EDLA09~16DA
Daikin Altherma 3 M
4P620243-1 – 2020.06
0000
User
Advanced user pin code
The
Advanced user
pin code is 1234 . Additional menu items for the
user are now visible.
1234
Advanced user
4.2 Space heating/cooling
To turn room temperature control ON or OFF
1 Go to [C.1]: Operation > Room .
Operation
Room
Space heating/cooling On
On
C.1
2 Set operation to On or Off .
To turn space heating/cooling operation ON or OFF
NOTICE
Room frost protection. Even if you turn OFF space
heating/cooling operation ([C.2]: Operation > Space
heating/cooling
), room frost protection –if enabled– will
remain active.
NOTICE
Water pipe freeze prevention. Even if you turn OFF
space heating/cooling operation ([C.2]: Operation >
Space heating/cooling
), water pipe freeze prevention –
if enabled– will remain active.
1 Go to [C.2]:
Operation
>
Space heating/cooling
.
Operation
Space heating/cooling
Tank Off
On
On Room
C.2
2 Set operation to On or Off .
To change the desired room temperature
During room temperature control, you can use the room temperature
setpoint screen to read out and adjust the desired room temperature.
1 Go to [1]:
Room
.
Room
1
2 Adjust the desired room temperature.
+
–
21
°C
1
a b
Room
a Actual room temperature
b Desired room temperature
To change the desired leaving water temperature
You can use the leaving water temperature setpoint screen to read
out and adjust the desired leaving water temperature.
1 Go to [2]: Main zone or [3]: Additional zone .
Main zone
2
Additional zone
3
2 Adjust the desired leaving water temperature.
+
–
35
°C
2
a b
Main zone
+
–
45
°C
3
a b
Additional zone
a Actual leaving water temperature
b Desired leaving water temperature
To change the weather-dependent curve for the space heating/
cooling zones
1 Go to the applicable zone:
Zone Go to …
Main zone – Heating [2.5] Main zone > Heating WD
curve
Main zone – Cooling [2.6] Main zone > Cooling WD
curve
Additional zone – Heating [3.5] Additional zone >
Heating WD curve
Additional zone – Cooling [3.6]
Additional zone
>
Cooling WD curve
2 Change the weather-dependent curve.