2. Cut off the windshield glass adhesive by a cutter knife or
the like to make a small hole, in order to pass a piano wire
through the hole.
CAUTION:
·
Be very careful not to damage the paint surface and
windshield by the cutter knife or the like.
NOTE:
·
Change the position of the hole to be made if any diffi-
culty is encountered, because spacers or retainers are
installed at some parts.
·
For quicker operation, make a hole on the adhesive
agent with a heated wire.
CAUTION:
·
Be very careful not to get scalded during the operation.
3. Pass the piano wire through the adhesive agent.
4. Hold both ends of the piano wire by pliers or the like and
cut off the adhesive by pulling the piano wire one side to
the other.
NOTE:
·
Some parts are hard to be cut off, because spacers or
retainers are built in between the glass and the body
panel.
5. Remove the windshield glass.
6. Remove the remaining material of the stopper and dam
from the windshield glass frame.
7. Clean the adhesive applying part of the windshield glass
frame and windshield glass as follows.
CAUTION:
·
Degrease the blade of a cutter knife before it is put into
use.
The surface of the adhesive agent that was cut by the
piano wire should be made flat by means of a cutter knife,
while leaving a thin layer of the adhesive material.
BO–71
Adhesive agent
JBO00187-00159
JBO00188-00160
JBO00189-00161
