DAIHAN-Sci.com or
ALL
for
LAB.com
Shopping Mall
DAIHAN Scientific, Forced Convection type Smart Oven 7/80
2. Installation
2.1 Product Installation
* Caution of Installation
1.
The product is heavy. Be aware when moving the product.
2.
Do not lay the product or allow sudden impacts. It may cause damage to the inside.
3.
Install the product on a hard, flat surface and ensure to use in a stable location.
4.
Do not install in dangerous locations or in where exposed to direct sun-light.
5.
If moisture or organic solvent is allowed into the body or adjuster part, it may cause a short
circuit. Avoid those locations.
6.
Ensure to check the voltage before the product installation for it is manufactured to operate
at rated voltage.
7.
Make sure to use POWER CORD shipped with the product when installing or operating the
product.
8.
Do not install the product in environments where inflammable gas may leak or may explode
due to organic vapor gas.
9.
Make sure to prevent moisture, organic solvent, dirt, corrosive gases from the product.
10.
Do not expose the product to direct heat sources.
* Installation Process
1.
After receiving the unit and locating it in the specified location, remove the packaging.
2.
Check the unit for any transport damages. If any such damages are found, please contact
the deliverer of the product.
3.
This Product is not equipped with casters. Units should be moved using a cart. Ensure that
no damage is sustained by the units during transport. It is recommended that units are
moved by at least 2 people and by lifting units up holding the indicated positions in the
figure below.
4.
The product should be positioned in a location where it has enough space for ventilation
and prevention from fire. The recommended distance of each side is minimum 20cm from
2
