DAIHAN-Sci.com or
ALL
for
LAB.com
Shopping Mall
High Performance Dry Bath Heating & Cooling
7/48
Do not operate the unit outside.
Avoid areas where the sun shines or rain directly on the unit. It is very dangerous
as cause over-heat or a short circuit.
Do not install the unit where it can get damp or dust.
It may be caused overheating, a short circuit or a fire by damp or dust inside of the
unit.
Do not use this unit when temperature fall below 5
°
C and rise above 40
°
C.
Do not use the unit at a place with high temperature. Do not operate the unit near
a heater, blowing an air-conditioner. It may be caused an accident by over-heating.
The unit should be set at a well ventilated place.
Be sure the holes on the side or rear surface of the body are not blocked by a wall or
an object. And do not operate the unit at a poor ventilated place or use closed.
It may cause a fire or damage of the unit as not to release heat or insufficient
ventilation may result.
Set the unit a lightening place.
When you set the unit at a dark place, it may cause an unexpected accident by
mistake in operation.
Operating the unit (repeated in the Section 7)
WARNING
Be careful to operate the unit.
You should read this manual carefully before using.
The unit should only be operated by laboratory personnel especially trained for this
purpose and familiar with all precautionary measures required for working in a
laboratory.
Operate after check the safety of the unit.
If there is generated a slight shock or a poisonous gas from a sample, figure it out
and make sure the safety using dustproof or a gas mask.
