Dahua SD6AE series, Руководство по установке

Страница: 28 / 47

19
4.2 Hang-mounted Bracket Installation Steps
4.2.1 Installation Conditions
Hang-mounted speed dome can be installed on hard wall structure in both indoor and outdoor
environments. The wall needs to meet the following installation conditions:

The wall shall be thick enough to install expansion bolts.

The wall needs to sustain at least 8X weight of the camera and bracket etc.
4.2.2 Installation Steps
Step 1
As it is shown in Figure 4-3, first loosen the M4 screw on the lateral of connection plate, separate
connection plate from the connection pole, and then lead in the composite cable from seal
groove which is located on the bottom lateral notch of the connection plate and pull it through the
center hole which is connected to flange. Fix the connection plate on the ceiling.
Figure 4-3
Note
It needs to use silica gel to cover the contact surface between connection plate and ceiling, cable
outlet area to make it sealed and waterproof if the speed dome is used outdoors.
Step 2
As it is shown in Figure 4-4, pull the cable through connection pole, rotate the connection pole to
the connection plate and tighten M4 screw firmly, then push the decoration cover to the bottom.