Dahua SD6AE series, Руководство по установке, Страница: 14 / 47

5
Figure 2-3
2.3.2 DIP Switch Setup
Users must set the address number, baud rate and parity parameters of speed dome before
controlling it. Only after all these settings are completed, can the speed dome respond to its
control commands.
Note

As for the wall-mounted speed dome, you need to install back the transparent cover
component after taking out the EPE and setting DIP switch address.

It has to cut off the power and reboot the device after relevant info has been reset, which
makes the new settings valid.
There are two DIP buttons on the speed dome PTZ which are used to confirm the speed dome
address, baud rate and parity. It is 1 when you set the button as ON. For address setup DIP, 1 is
the lowest bit, 8 is the highest bit; for the Baud rate and parity setup DIP, 1 is the lowest bit, 4 is
the highest bit. (Intelligent speed dome self-adapt to PELCO-D, PELCO-P, industrial standard
protocol, control protocol don
’t need DIP setup).
2.3.3 Address Setup
The speed dome uses DIP switch to set address, the encoding mode adopts binary system. 1 to
8 is valid bit. The highest address bit is 255; see Figure 2-4 for address label and you can refer to
Table 2-1
for more information about address bit setup.