Dahua DHI-ISC-EAA6000-P, Руководство пользователя

Страница: 15 / 28

User’s Manual
10
3.3.3 Description of RX Board Ports and Manual Configuration of
Hardware
RX board ports
Table 3-4 RX board ports and manual configuration of hardware
Port Description
J1
Use 9 Pin cable to connect to CH1/CH2/CH3 of the TX board of
primary antenna, remember that cold plug, electrical hot plug will
cause damage to the TX board.
J10
1&2=L Low
3&4=M Medium
5&6=H High
Set the sensitivity of antenna receiving.
From top to bottom:
Low, Medium, High
It can be adjusted according to ambient conditions on site, and the
factory default setting is M.
When there is a lot of interference on site, try to place the jumper in
a low gear(L) to reduce the antenna's ability to sense interference,
improve the antenna's ability to detect, and reduce the false alarm
rate.
RX 1 receiving coil for connecting the antenna.
LIGHT 1 alarm indicator for connecting the antenna.
BEEP 1 Buzzer port.
R166
1potentiometer for adjusting alarm volume.
Use a Philips screwdriver, turn clockwise to increase the volume,
and turn counterclockwise to decrease the volume.
J7 1 port for power indicator.