Dahua DHI-ARC3008C, Руководство по установке

Страница: 45 / 111

Alarm Control Panel Installer Manual
44
Submenu Setting
MODALITY
The Area output can be programmed to follow the Areas condition for AND
or OR mode.
If only one area has been assigned, this parameter has NO value. If 2 to 8
areas have been assigned, the behavior of the output must be defined for
the presentation of the TYPE event in multiple areas.
OR: The output activates when the event occurs in one of the 
assigned areas and deactivates when there is a reset from all the
assigned areas.
AND: The output activates when the event occurs in all of the 
assigned areas and deactivates when there is a reset from at least
one of the areas.
If only one area has been assigned, this parameter has no value.
POLAR
Select the output polarity. The choice of the output polarity determines the
at rest status of the output itself. In practice, the output can be placed in
HIGH or LOW electrical status (high status gets more security)
DIRECT 
REVERSE 
If you press to confirm the option, you will exit and the output will
immediately take on the selected polarity.
ZONES Outputs
Table 1-17 Zones outputs programming
Submenu Setting
TYPE
ZONE FOLLOW: Follows the direct status of the zone (open and

closed).
ZONE ALARM: Follows the zone alarm status until reset.

ZONE BYPASS: Follows the bypassed zone status.

ZONE TAMPER: Follows the tamper status.

ZONE1/ZONE2/
ZONE3/ZONE4
You can associate the output with up to a maximum of 4 different Zones
(wire or radio Zones)
MODALITY
The ZONE outputs can be programmed to follow the association condition
for AND and OR mode.
If only one ZONE has been assigned, this parameter has NO value. If 2 to
4 ZONES have been assigned, the behavior of the output must be defined
for the presentation of the event by multiple zones.
OR: The output activates when the event occurs in one of the

assigned areas and deactivates when there is a reset from all the
assigned areas.
AND: The output activates when the event occurs in all of the

assigned areas and deactivates when there is a reset from at least
one of the areas.