Web Configuration 47
Radar (ANPR)
Figure 6-45
Check
Enable Radar
, and then you can configure the parameters. See Table 6-11.
Step 2
Table 6-11 Radar (ANPR)
Parameter
Description
Enable Radar
Check to to enable radar function.
COM SET
COM Port
Select the corresponding COM port. COM1/2/3 corresponds to
Lane1/2/3 respectively.
Radar Type
Select the radar type. The parameters of selected radar need to
be configured at the right side of the interface.
Speed Limit Config
For Size
disabled
You can configure the low/high speed limit.
For Size
enabled
You can configure the low/high speed limit by vehicle size (small
vehicles (SV) and large vehicles (LV)).
ITARD-024
SA-I
Work Mode
The way of sending information captured by Radar. You can
select Single, Continuous or Manual.
Currently, the Camera supports only Single. Special program is
required if you want to send the information in continuous or
manual way.
Interval
The radar will recognize only one subject within the interval.
This function is available with the support of special program.
Detect Mode The detection direction of radar.
Angle
The angle between the directions of the radar beam and the
vehicle.
Sensitivity
You can select the sensitivity of snapshot by radar. The larger
the value, the more sensitive the radar.
Trigger
Speed
Snapshot will be triggered when the vehicle speed reaches the
trigger speed.
Pre Speed
Wait
Recognizing the vehicle speed. By video analyse and radar
detection, the Camera can detect the vehicle speed. If the
