PFA110
Mount Adapter
PFB300S
Wall Mount
PFA120
Junction Box, optional
PFA140
Power Supply Box, optional
Use the power supply box to
make external cable
connections.
Mounting the Camera
1. Place the Wall Mount (PFB300S), junction box (PFA120), or power supply box (PFA140) against
the wall and mark the location of the center hole (for PFB300S and PFA120 only) and the four
perimeter mounting holes.
2. Pre-drill the four perimeter holes as marked on the wall for the expansion bolts, using a drill bit
that is no wider than the expansion bolt.
3. Drill a 50-mm (approximately 2 in.) center hole to route the cables, if necessary.
4. Insert an expansion bolt into each pre-drilled perimeter hole.
5. Secure the Junction Box or the Power Supply Box to the wall using four hex bolts and four flat
washers, if using. Do not secure the Wall Mount (PFB300S) to the wall at this step.
6. Screw the mount adapter block into the internal thread of the wall mount bracket, until secure and
then fix the set screw on the Wall Mount.
7. Pull the composite cable from the dome through the adapter block and pull it out of the other
end of the wall mount bracket.
12
