Daewoo FRS(N)-U20IA, Руководство по обслуживанию

Страница: 86 / 143

85
11-4. Water Line Installation
1.The water pressure should be 3kgf/cm2 or more to run the
automatic icemaker.
※
Checkup your tap water pressure ; if a cup of 180cc is full
within 10 seconds, the pressure is OK.
2.When installing the water tubes, ensure they are not close to
Any hot surface.
3.The water filter only “filters” water ; it does not eliminate any
bacteria or microbes.
4.If the water pressure is not so high to run the icemaker, call the
local plumber to get an additional water pressure pump.
5.The filter life depends on the amount of use. We recommend
you replace the filter at least once every 6months.
※
When attaching the filter, place it for easy access (removing
& replacing)
6.After installation of refrigerator and water line system, select
[WATER] on your control panel and press it for 2~3 minutes to
supply water into the water tank and dispense water.
7.Use sealing tape to every connection of pipes/tubes to ensure
there is no water leak.
8.The water tube should be connected to the cold water line.
How to install Water Line
1. Join connector to water tap
Installation Procedure
1)First lock the main tap water valve.
Check if connector B and C has its own rubber packing ring in it.
2)Join Connector C to the water tap, then Connector B to
connector C with a wrench or spanner.
3)Insert water pipe into Connector-B and join Connector-A with a
wrench or spanner.
4)In case Connector-C does not fit water tap join Connector-B
directly to the tap. (See Figure B.)
※
If no connector fits water tap, call your local service.
5)Unlock main tap water valve, open tap water and check if any
water leaks on each joins.
Place the rubber washer inside the tap connector and
screw onto the water tap.
2. Get ready to install water line
1) Measure an approximate distance between the filter and the
Water Tube and cut the tube off filter vertically.
2) Connect the tubes to the filter as the figure shows.
Leave a sufficient distance when cutting the tubes.