41
R
ELECTRICAL REQUIREMENTS FOR ELECTRIC DRYERS
The following are additional instructions regarding electrical connections and requirements for electric dryers.
Instructions for Grounding of your Electric Dryer:
a) This dryer must be connected to a grounded metal, permanent wiring system or an equipment–
grounding conductor must be run with the circuit conductors and connected to the equipment–grounding
terminal or lead on the dryer.
D6JGFT[GTJCUKVUQYPVGTOKPCNDNQEMVJCVOWUVDGEQPPGEVGFVQCUGRCTCVG*GTV\UKPINGRJCUG#%
circuit, fused at 30 Amperes
(the circuit must be fused on both sides of the line).
ELECTRICAL SERVICE FOR THE DRYER SHOULD BE OF MAXIMUM RATE VOLTAGE LISTED ON
THE NAMEPLATE.
DO NOT CONNECT DRYER TO 110, 115, OR 120 VOLT CIRCUIT.
c) If branch circuit to dryer is fifteen feet (4.50 m) or less in length, use U.L. (Underwriters Laboratories)
listed No. 10 A.W.G. wire (copper wire only), or as required by local codes.
If over fifteen feet (4.50 m), use U.L. (Underwriters Laboratories) listed No. 8 A.W.G. wire (copper wire
only), or as required by local codes.
#NNQYUWHHKEKGPVUNCEMKPYKTKPIUQFT[GTECPDGOQXGFHTQOKVUPQTOCNNQECVKQPYJGPPGEGUUCT[
F 6JGRQYGTEQTFRKIVCKNEQPPGEVKQPDGVYGGPYCNNTGEGRVCENGCPFFT[GTVGTOKP5016UWRRNKGF
with dryer.
Type of pigtail and gauge of wire must conform to local codes and with instructions mentioned on the
following pages.
G6JGOGVJQFQHYKTKPIVJGFT[GTKUQRVKQPCNCPFUWDLGEVVQNQECNEQFGTGSWKTGOGPVU4GHGTVQGZCORNGUQP
next page.
f) You must select the method by which to wire your dryer according to local code and ordinance
requirements.
Sample methods are included in the following pages.
120V/ 240V, 60 Hertz, 3–Wire Installation
Important Warning
6QJGNRRTGXGPVſTGGNGEVTKEUJQEMUGTKQWUKPLWT[QTFGCVJVJGYKTKPICPFITQWPFKPIOWUVEQPHQTOVQVJG
latest edition of the National Electrical Code, ANSI/NFPA 70 and all applicable local regulations.
2NGCUGEQPVCEVCSWCNKſGFGNGEVTKEKCPVQEJGEM[QWTJQOGŏUYKTKPICPFHWUGUVQGPUWTGVJCV[QWTJQOGJCU
adequate electrical power to operate the dryer.
Содержание DWR-WG52S
