Daewoo DWR-WG52S, Руководство по обслуживанию

Страница: 34 / 82

33 33
2-6. Error Mode
1) H1 error – Humidity sensor error
①
This occurs when there is a short defect in the humidity sensor (the indicated value is lower than 24)
②
The unit buzzes, indicating the error, every 10 minutes for 10 seconds.
③
The error display goes off when the power is switched on/off.
2) H2 error – Drying temperature sensor open/short error
①
This occurs when there is a defect in the drying temp sensor or disconnection.
②
The unit buzzes, indicating the error, every 10 minutes for 10 seconds.
③
The error display goes off when the power is switched on/off.
3) H5 error – Heater overheated (ELECTRIC TYPE)
①
This occurs when the temp sensor indicates 85° or higher.
*GCVGTFKUEQPPGEVKQPEJGEMCPF**GTTQT'.'%64+%6;2'
①
0QGTTQTKUKPFKECVGFKPECUGQHCEVWCNEQPUWOGTWUGHQTVJKUOQFGEJGEMUJGCVGTFGHGEVUVJTQWIJEWUVQOGT
service.
②
6JGFGHGEVOWUVDGEJGEMGFYKVJQWVCP[NQCF
③
*QYVQGPVGTVJGOQFG2WUJVJGRQYGTDWVVQPYJKNG&T[$GGRCPF/QTGDWVVQPUCTGRTGUUGFCVVJGUCOG
time.
④
Then, Heater 1, Heater 2, and the motor are turned on.
⑤
%JGEMVJGVGORKPKVKCNN[CPFOKPWVGUNCVGT/GCUWTGVJGFKHHGTGPEG
If the difference is 20°C or greater, “OK” is indicated.
If between 5°C~19°C, “H6” is displayed, indicating disconnection of one heater.
If 5°C or below, “H4” is displayed, indicating disconnection of two heaters.
5) H3 Error – Flame Detector Open Defect (Gas Type)
①
2TKQTVQKIPKVGTQRGTCVKQPKVKUEJGEMGFYJGVJGTHNCOGFGVGEVQTKUCVVCEJGF*GTTQTQEEWTUYJGPHNCOGFGVGEVQT
is still open after 300 seconds.
*'TTQTŌ)CU8CNXG&GHGEVQT)CU$NQEMGFŌQHH)CU6[RG
①
H7 error occurs if flame detector maintains short state when operating gas valve after normal operation of
flame detector and igniter (error displayed after 5 repetitions).
7) H8 Error – Igniter Defect or Flame Detector Short (Gas Type)
①
Flame detector must open within 120 seconds after igniter operation. H8 error occurs when the initial state of
short is maintained after the 120 seconds (error displayed after 5 repetitions).