|
27
|
[1] The smell of excess waste in drainage flows back.
You need to clean the drainage
regularly.
[2] Review the error indications E5, E6, E7, and E8 and then contact the sales store or
service center.
[3] Check whether the water supply valve is open.
[4] Did you use too much detergent? If the laundry gets excessively foam, the washer
drains water even in the middle of a wash cycle.
[5] The washer resumes water supply to balance the laundry in the drum in a spin cycle.
[6] The low water pressure lengthens the water supply and the entire cleaning cycle as
well.
[7] Towel may get stiff as the front load washer cleans the laundry by utilizing falling
pressures. Use fabric softener to reduce the stiffness.
[8] Check whether the power cord is properly connected to the washer.
[9] The remaining time increases when the laundry is unevenly located in the drum.
[1] Unpleaser smell for drum.
[2] The washer stops running in the
middle of a wash cycle.
[3] The water supply doesn't start
after running the washer.
[4] The washer drains water while
washing clothes.
[5] The water supply starts in the
middle of a spin cycle.
[6] The wash cycle takes too long.
[7] Towels are stiff after washing.
[8] The washer makes strange
noises during a spin cycle.
[9] The remaining running time
fluctuates.
[10] The washer heats the water to raise the water temperature during a wash. The
remaining time may not change for a while in winter as the washer heats the water to a
preset temperature.
[11] The buzz is caused by the electronic break to suspend the spin cycle. It is not caused
by a mechanical problem.
[10] The remaining running time
doesn't change.
[11] The washer buzzes when the
spin cycle stops.
[12] Front load washers consume a small amount of water for washing.
- The water surface is not easily identifiable due to the low water level, but this is not
caused by a mechanical problem.
- The front load washer consumes a small amount of water as it soaks the laundry with
water and washes and rinses it by rotating and dropping the clothes.
[12] A small amount of water is
supplied to wash or rinse
laundry. (Low water level)
[13] The washer resumes water supply after detecting the quantity of water and laundry
condition to improve washing efficiency. It may be caused by either of the following
reasons.
- Laundry was added after starting a wash cycle.
- The low water level activates the water supply automatically.
[13] The water supply resumes
during a wash or rinse
cycle.
[14] When detergents were applied excessively or the drain hose is bent upward in the
middle so that the water is not properly drained, the spinning speed may decrease.
Drain the water and then resume the spin cycle.
[14] The drum is not spinning or
it is running slowly for a
while after the spin cycle
starts.
Problems
Causes
- Some troubles are wrongly considered to be mechanical malfunctions although they are not.
- If any malfunctions are suspected, you may contact the sales store or service center with inquiries.
When malfunctions are suspected
DWD-CV701PC_Cotton_ZORA.indd 27
2014-11-18 오전 11:41:35
