Daewoo DWC-ED1213, Руководство по обслуживанию

Страница: 40 / 65

36
* Replaceing method of Heater and Temp. Sensor
1. Disassemble Connector
2. Disassemble EARTH and NUT for fixing heater
3. Replace heater & sensor
4. Assemble in the reverse order. Be sure to assemble in the order : Nut for heater-Nut for EARTH.
* Structure of DUCT B As
1. Heater Dry
2. Diecasting DUCT
3. Thermistor Dry
4. FAN MOTOR
5. Fuse Temp.
6. Switch Bimetal
7. FAN
* ERROR MODE
1. "H1" : Thermistor Dry OPEN/SHORT
2. "H2" : Thermister Wash OPEN/SHORT
3. "H3" : Dry Overheating(Sensing Temp. is over 125
℃ ℃
)
4. "H4" : Wash Overheating(Sensing Temp. is over 95
℃ ℃
)
5. "H5" : Wash Overheating
(In Wool, Lingerie courses sensing temp. is over 45
℃ ℃
)
6. "H6" : Abnormal condition of Heater Wash
(when the temp. increase at 10 minutes after heater operation is under 10
℃ ℃
)
7. "H7" : Abnormal condition of Heater Dry(when the temp. increase at 10 minutes
after heater operation is under 10
℃ ℃
)
8. "H8" : Heater Wash Overheating
(when the temp. increase within 30sec after heater operation is over 5
℃ ℃
without water)
9. "E3" : FAN MOTOR Broken(no signal from HALL IC)