DAELIM Roadwin R, Руководство по обслуживанию

Страница: 133 / 295

9-5
A.C GENERATOR / STARTER CLUTCH
STARTER IDLE GEAR INSPECTION
Inspect the wear and damage of starter ldle gear.
Measure the gear inside diameter.
SERVICE LIMIT : 10.100mm
Measure the gear shaft outside diameter.
SERVICE LIMIT : 9.970mm
REDUCTION GEAR INSPECTION
Inspect the wear and damage of reduction gear.
Measure the gear inside diameter.
SERVICE LIMIT : 10.100mm
Measure the gear shaft outside diameter.
SERVICE LIMIT : 9.970mm
REDUCTION GEAR
STARTER IDLE GEAR
INSTALLTION
Install the starter driven gear collar.
Clean the taper part of crank shaft and remove the
dust. If installing the rotor with dust in taper part,
the key will be damaged. Because the contacted
area of taper will be small and it will occur the
stress in the woodruff key.
Install the woodruff key into the crank shaft key
groove.
Install the rotor into the crank shaft aligning the
key.
Install the rotor bolt temporarily. After fixing the
flywheel with a holder, tighten the rotor bolt.
TORQUE : 5.5kgf m(55N m)
TOOL: FLYWHEEL HOLDER
After checking whether inside magnet of rotor is
attached by the bolts and nuts, install them.
If installing the rotor with the foreign material, the
starter coil is damaged.