DAELIM Roadwin 250R Fi, Руководство пользователя

Страница: 51 / 68

49
A rubber part is assembled on the cable to
protect the inner cable.
Make sure that this part is placed firmly
around the correct part of the cable.
When washing the car, do not directly
spray water on to the rubber part is dirty,
use a dry cloth to clean this area.
CABLE RUBBER PART
RUBBER
(NORMAL)
LOCK NUT
RUBBER BOOT
●
Infiltration of the foreign materials or
water caused by damage of rubber
boots (disengagement, tearing, etc.)
may cause freezing in winter season
resulting in faulty operation. It may
lead death or serious injury by
decreasing of sudden acceleration and
braking force due to engine rpm.
●
If any damage is found, replace with
the new on immediately.
CLEANING
●
Make sure to stop the engine prior to
car washing.
●
Be careful not to allow water to enter
the muffler during the washing.Water
inside the muffler may cause an
improper engine starting or rust
occurrence.
●
Do not let water get inside the braking
system during the washing, as water
inside the brake system may weaken the
braking power. Upon completion of
washing, select a safe place where there
is no traffic obstruction, and start the
vehicle.
Lightly apply the brake while driving at
a slow speed and check the braking
power. If the braking power has been
weak-ened, apply brake lightly while
driving at a slow speed to dry up the
brake system.
●
Take precautions when waxing the
vehicle. Excessive polish of the painted
section and/or the resin part with
compound wax might damage the
painted section causing discoloration of
the affected area.
●
Check the installing condition of rubber
boots daily. After adjusting the free play
of throttle grip never forget to place the
rubber boots to the original position.