Daedong KIOTI EX35, Руководство пользователя

Страница: 170 / 238

6
-
1
6
-
16
3-poInt HItcH ImpLement opeRAtIon ex35(c)/ex40(c)/ex45(c)/ex50(c)
6
-
1
6
-
16
3-poInt HItcH ImpLement opeRAtIon ex35(c)/ex40(c)/ex45(c)/ex50(c)
4. Regen.
the Regen. function is activated
when the joystick lever is pushed
one position further to the right
from the dump position.the Re-
gen means “fast duming”.
5. down & roll back
the boom can be lowered and the
bucket can scoop up by operat-
ing the joystick lever to the front
left position (10 o’clock position).
However, the operation time may
not be shortened much since the
boom is lowered first and then the
bucket is rolled back due to unbal-
anced hydraulic pressure in the
hydraulic circuit.
6. down & dump
the boom can be lowered and the
bucket can dump by operating the
joystick lever to the front right po-
sition (2 o’clock position). Howev-
er, these two operations may not
be performed simultaneously due
to unbalanced hydraulic pressure
in the hydraulic circuit.
7. up & roll back
the boom can be lifted and the
bucket can scoop up by operating
the joystick lever to the rear left
position (7 o’clock position). How-
ever, these two operations may
not be performed simultaneously
due to unbalanced hydraulic pres-
sure in the hydraulic circuit.
8. up & dump
the boom can be lifted and the
bucket can dump by operating the
joystick lever to the rear right po-
sition (5 o’clock position). Howev-
er, the operation time is may not
shortened much since the buck-
et dumps first and then the boom
is lifted due to the unbalanced hy-
draulic pressure in the hydraulic
circuit.
9. Locking/unlocking joystick
pressing the joystick lock lever in
locks the joystick while pulling it
outward unlocks the joystick as
shown in the figure.

Do not leave the tractor with
the boom off the ground in any
circumstances. If it is neces-
sary, lock the joystick.

when the joystick lever is not
in use, lock it since the imple-
ment can fall down if the lever
is operated accidently.
wARNINg

If the boom or bucket is not
operating, properly, lower the
bucket onto the ground, stop
the engine, and reduce all hy-
draulic pressure. Then, check
all the hydraulic connections
and connect them again.

Before connecting or discon-
necting the hydraulic hose
coupling for the loader, low-
er the boom onto the ground,
stop the engine, and move the
joystick lever front and back,
left and right for several times
to remove residual pressure in
the hydraulic hose.
IMPORTANT
M47-EU-06.indd 16 2012-03-15 오후 2:56:22