18
Installation Instructions
WARNING
Installing the RNIVS requires two people
.
Do not attempt to lift and hold the RNIVS without assistance.
Wear protective gloves while holding the unit. Sharp edges can cause injury to hands and fingers.
Installing the RNIVS
NOTE:
If using the RNIVS without a liner kit, use
a 3/8” spacer.
See the next page.
Rear mounting holes
Top mounting holes
T
R
Mounting Holes
NOTE:
If using a liner kit with the RNIVS, please
follow the instructions on page 13.
When hanging the RNIVS, be careful not to scratch or
damage the unit.
1. Remove the plastic film from the RNIVS.
2. Install a 3/8” spacer on the back of the RNIVS, or
install a spacer on the canopy or wall.
Refer to the figures on the facing page.
3. Choose and measure the top and rear mounting holes
that will mount the RNIVS to the canopy or wall. See
figure,
Mounting Holes
at right.
Mark the measurements on the canopy or wall.
This is where screws will hold the RNIVS to the wall
studs or anchors.
4. Drill pilot or anchor holes. If using anchors, insert them
into the anchor holes.
5. Raise and adjust the RNIVS into its final position, and
fasten it into place using appropriate mounting screws
or fastening hardware.
T
T
R
R
