Dacor HWHE30, Руководство по установке

Страница: 15 / 24

13
1. Turn the hood on its top so the tip of the blower can
extend beyond the exit vent.
2. Insert the blower into the exit vent with this specific
placement:
When standing at the back of the hood and looking down
at the blower (previous graphic):
• The blower I/O port must be on the right
• The blower exhaust port must be against the hood back.
Finalizing the Rear-Vent Setup
1. Refasten the cable clamps and assembly to the hood.
2. Connect the cable assembly to the blower’s I/O port.
3. Attach the duct collars to the back of the hood.
4. Return the hood to a safe, upright position.
Installation Instructions
Rotating the Blower(s) for Rear
Exhaust, cont.
Orientating the Blower(s)
The blower(s) must be correctly positioned. Ensure the
blower I/O port is against the back of the hood. Compare it
with this graphic:
Blower I/O port
(on right when facing
back of hood)
Back of Hood
Front
of Hood
Bottom of Hood
Blower
tip
extends
here
Replacement
Part #
Description
702579 Baffle Filter Kit (1 pc + hardware)
702580 Baffle Filter Kit (2 pc + hardware)
Assembling the Filters
Filters are boxed separately and must be assembled during
installation. All needed knobs and hardware are included
with the filters.
For correct orientation, ensure the top of the filter faces up.
The filter’s face has:
• plastic peel-away coating
• beveled lip on the inside frame
• screw holes on the ridge (not down in the trough)
Instructions
1. Remove the plastic coating, and make sure the beveled
lip faces up.
2. Align the screw, lock washer, and knob with the filter.
Make sure the knob is on the ridge , and the screw and
lock washer are in the trough .
3. Twist and tighten the knob onto each washer/screw.
4. Continue the hood installation, then install the filters
after hanging the hood.
HWHP/HWHE/RNHP/RNHE Baffle-Style Filter