Dacor HWHE30, Руководство по установке

Страница: 19 / 24

17
Installation Instructions
WARNING
• Do not ground the circuit to a gas line.
• Do not ground the circuit to a hot water pipe.
• Insulated water lines must be jumped to assure continuity to the ground. (See below.)
Insulated Pipe Jumper
(if necessary)
GREEN
GREEN
WHITE
WHITE
BLACK
BLACK
Grounding by External Cold-Water Pipe
UL/CSA-approved
NEMA strain relief
Fasten clamp tightly
on metal pipe
Separate No. 10 (minimum)
copper ground wire
To house circuit
breaker panel or
fuse box
To Range Hood
Wire nut,
3 places
Junction box
Meter
Clamps
Bare metal
No. 4 copper
wire
Inserting Light Bulbs
Be sure to use dimmable bulbs. The electronic board was
designed for dimmable lights. Using non-dimmable bulbs
causes damage and faulty performance.
Before changing bulbs, shut the main circuit breaker OFF.
An electrical short while the main power circuit is ON, can
cause significant damage.
If needed, clean the lens surface so the suction cup will
stick to it.
Perform this procedure for each hood light.
1. Attach the suction cup to the lens of a dimmable light
bulb (both supplied, see the graphic at right).
2. Screw the bulb into the light fixture, and remove the
suction cup.
3. Switch the main circuit power ON.
Replacement
Part #
Description
702666
Dimmable LED Bulb Replacement Kit
(1 bulb + 1 suction-cup tool)