Dacor HDPR48S, Руководство по установке

Страница: 22 / 36

22 English
Installation Instructions
Preparing for Installation, cont.
Installing the Anti-tip Bracket and Foot, cont.
Wall-Mounting the Anti-tip Bracket
For this option to be suitable, the forward edge of the range's front panel must be 26 1/2” (67.3 cm) or less
from the wall, and the bracket screws must be able to engage the base plate inside the wall. Notches on
the sides of the bracket indicate the minimum height of the base plate and that any floor-covering thick -
ness will not impede secure threading.
5. Having determined the wall-mounting is suitable, place the bracket against the wall in the mounting
location.
6. Using a drill with 1/8” diameter bit, drill four 1 5/8” deep pilot holes perpendicular to the screw-seating
surfaces shown.
7. Attach the bracket to the wall as shown with the four included #12 x 1 3/4 screws.
ANTI-TIP BRACKET PLACEMENT
Dim. 30, 36 48
C 14 1/8” (35.9 cm) 3 1/2” (8.9 cm)
1. Using product dimensions on Pg. 13 and actual cabinet/
cutout dimensions, determine the position of the range's
centerline and front panel when the range is in its final
position.
2. Based on the diagram on Pg. 18, determine and mark the
position of the anti-tip bracket. Set the bracket in place
against the wall.
3. With a pencil, make a dot next to the notches on both
sides of the bracket.
4. (Determine if the base plate is as high as the notches)
With a 1/₁₆” drill bit, drill test holes in the wall at both dots.
Drill just deep enough to see if the bit contacts the base
plate. If there is contact, you can wall-mount the bracket.
If there is no contact, wall mounting is unsuitable, and
you must either floor-mount the bracket, or alter the wall,
adding base material above the notches.