Dacor HDPR48S, Руководство по установке

Страница: 21 / 36

21 English
Preparing for Installation, cont.
Installing the Anti-tip Bracket and Foot, cont.
Floor-Mounting the Anti-tip Bracket, cont.
• Determine the anti-tip bracket location (see the diagram below). Mark the 4 hole locations on the floor.
• Determine screw size. Minimum full thread depth (portion of screw threaded into the sub-floor) is 3/8” (1
cm) for wood and 5/8” (1.6 cm) for concrete. (See the SCREW SIZE table, below, for correct screw sizes.)
Attaching the Bracket to a Concrete Floor
1. Drill four 3/8” dia. countersink holes through the
flooring but not into the concrete.
2. Through these holes, drill 4 anchor holes 1¼”
(3.2 cm) into the concrete with a ³/₁₆” masonry
bit. This hole length is longer than the anchor.
3. Clean out the holes, and tap in each anchor so
its top is flush with the concrete surface.
4. Align the bracket and anchor holes, then insert
and tighten the screws.
Attaching the Bracket to a Wood Sub-Floor
1. (Ceramic, stone, other hard flooring over wood)
Drill 4 countersink holes to access the wood for
drilling pilot holes.
2. Drill 4 pilot holes (1/₁₆” dia. bit for #8 screws, 1/8”
dia. for #12 screws). Align the bracket and pilot
holes, then insert and tighten the screws.
Installation Instructions
SCREW SIZE
Sub-floor Type/Floor Cover Thickness Screw Size
Concrete/wood sub-floor; no floor cover
#8 x 1*
Concrete/wood sub-floor; flooring up to
¼” thick
Concrete/wood sub-floor; flooring ¼” – 1/2”
thick
#8 x 1 ¼*
Wood sub-floor; flooring over 1/2” up to 1
³/₁₆” thick
#12 x 1 3/4*
Concrete under flooring over 1/2” thick
Purchase
separately**
Wood under flooring over 1 ³/₁₆” thick
*Included with range; **determine required depth based on info
in Step 3, and purchase from hardware store.
ANTI-TIP BRACKET PLACEMENT
Dim. 30, 36 48
A 13” (33.0 cm) 3 1/2” (8.9 cm)
B 22 1/2” (57.2 cm) 22 1/2” (57.2 cm)