Installation Instructions
Remove the toe kick
mounting plate to expose
the front legs. To adjust
the front leveling legs,
place a wrench on the
top of each leg and
adjust where the top of
the dishwasher tank front
trim is flush with the lower
edge of the countertop.
To adjust the rear leveling
legs, rotate the #2 Phillips drive shafts, located at the
toe-kick, to level the dishwasher from front to back and
left to right.
It is important to level the dishwasher from left to right and
front to back. Shimming may be required on extremely
uneven flooring materials. If shims are needed, place the
shim(s) under the adjustable legs.
IMPORTANT:
Do not reinstall the toe kick mounting plate until the
installation is inspected for leaks (see page 11).
Make sure to anchor at least one anti-tip bracket on
each side of the dishwasher.
The anchoring material must be no more than 1/4”
(6mm) from the anti-tip bracket.
3.
4.
•
•
•
Attach the Anti-Tip
Brackets
CAUTION
Make sure to anchor at least one anti-tip bracket on
each side of the dishwasher.
The anchoring material must be no more than 1/4”
(6 mm) from the anti-tip bracket.
To prevent leaks, square the dishwasher in the
cutout. When attaching the anti-tip brackets make
sure the tub and frame are not skewed so that the tub
gasket contacts the door liner fully all the way around
the door.
•
•
•
The anti-tip brackets protect against possible tipping
caused by heavy bottom rack loads on the door.
There are anti-tip mounting locations provided around
the top and sides of the dishwasher front frame.
To attach the anti-tip bracket anchors:
Insert the anchoring screws through the 1/2” diameter
access holes inside the dishwashing compartment on
the ceiling and the sides, near the front. Make sure
that the anchoring screws pass through the anti-tip
brackets located on the outside of the dishwasher.
Alternate method:
Insert the anchoring screw through the 1/2” diameter
tank access hole. Make sure that the anchoring screw
passes through the anti-tip bracket located on the
outside of the dishwasher.
Square up the installation:
Check to make sure the dishwasher is square in the
cutout by observing the door to tub alignment on each
side. Readjust the top or bottom of the unit as needed
to square up the unit.
•
•
•
•
•
Leveling the Dishwasher (continued)
Front leg
adjustment
nut
Rear leg
adjustment
hex rod
Top anti-tip
bracket
Side anti-tip
bracket
Front leg
Toe Kick Mounting Plate
(pull out to remove)