9
3. Insert two provided machine screws into the two
holes above the mounting bracket on the blower
assembly and tighten into place.
4. Insert two machine screws through the front of the
mounting bracket and tighten into place.
5. Insert two machine screws through the side of both
“L” brackets and tighten into place.
6. Attach the end of the duct system to the exhaust out-
let with duct tape.
Hanging the Blower Assembly
WARNING
Do not use screws to attach the duct work to the hood
exhaust outlet. Use duct tape only. Screws may prevent
the damper flaps on the top of the hood from opening.
1. Inside the exhaust outlet on the top of the blower
assembly, there are metal or plastic damper flaps.
The flaps close to help prevent back-drafts when the
blower is turned off. Remove the shipping tape and
make sure the flaps open and close freely before pro-
ceeding.
2. Lift the blower assembly up and put the mounting
hole on the top over the mounting bracket, while
inserting the exhaust outlet into the end of the duct
system. Gently lower the blower assembly onto the
lip of the mounting bracket. Slide the bottom part of
the blower assembly between the two “L” brackets.
Installation Instructions
Blower
assembly
Exhaust
outlet
Insert exhaust
outlet into end
of duct
Mounting
bracket
"L" brackets
