Dacor CM24T, Руководство по установке

Страница: 9 / 16

• Cut a section of the supplied Ø 4mm (5/32”) Teflon
hose long enough to connect between the coffee
system water inlet quick release fitting and the
regulator without binding or kinking.
• Insert one end of the Teflon hose (Ø 4mm) into the
quick-release fitting on the appliance. Then pull it out
slightly to make sure that it is secure.
• Connect the hose connected to the appliance to
the output of the regulator. Pay attention to the flow
direction arrows on the pressure regulator.
IMPORTANT: If you connect the hoses to the regulator
backwards, the water will not flow into the coffee
system and it will not work.
• Insert the end of the second hose into the input on the
regulator.
• Attach the third quick-release fitting to the second hose.
• With the main water valve closed, attach the quick-
release fitting to the water line from decalcification kit.
You can connect to a house water supply hose or water
line using a hose fitting (not supplied) that connects
to the 1/4-19 BSPP male thread on the quick release
connector.
I
nstallatIon
I
nstructIons
Pressure Regulator Adjustment
IMPORTANT: The water pressure at the output of
the pressure regulator may not exceed 3.0 bars/43.5
psi (1.5 bars/21.8 psi minimum). To adjust the output,
pull the pressure regulator control knob up slightly.
Turn it clockwise to increase the output pressure.
Turn it counter-clockwise to reduce the pressure. After
adjustment, gently push the control button back in.
Coffee System Water Inlet
Hose Fitting
(not supplied)
Quick Release
Connector from
regulator
Quick-Release Fitting
Pressure Regulator Adjustment
Control Knob