Dacor CM24T, Руководство по установке

Страница: 11 / 16

I
nstallatIon
I
nstructIons
I
nstallIng the
c
offee
s
ystem In the
c
abInet
• While supporting the coffee system from below, insert it
into the cabinet cutout. As you insert it into the cabinet,
line up the glides on the appliance with the cabinet
glides. The system should glide on the rails when slight
pressure is applied to the front of the coffee system. If
it does not glide smoothly, check the distance between
the glides again. See page 8.
• As you slide the coffee system into the cabinet the
locking tab on the glides will engage.
Locking Tab
Locking Tab Location
v
erIfyIng
o
peratIon
• Plug the coffee system into the dedicated, properly
grounded, 3-prong receptacle.
• Turn the light on and off to test it.
• Turn on the power switch, located below the control
panel.
• On model CM24P (plumbed model): turn on the water
supply at the shut-off valve. Check to make sure the
pressure regulator is set between 1.5 bars to 3 bars
pressure. Adjust the regulator if necessary.
• On model CM24T (tank model): Fill the tank with
filtered water (4 gpg maximum water hardness, do not
use distilled water).
• Push the hot water button. Wait about
six seconds.
• Continue to push the hot water button
every six seconds until air bubbles no
longer come out of the dispenser and about six ounces
of water is dispensed.
• Clean the coffee system according to the Routine
Cleaning and Milk Cleaning instructions in the use and
care manual. On model CM24T, clean the water tank.
• Put a sauce pan under the drink dispenser.
• Make one of each type of drink in the Basic Operation
Instructions section of the use and care manual.
If the coffee system does not operate properly, follow
these troubleshooting steps:
1. Verify that power and water are being supplied to the
coffee system. On CM24T, make sure the water tank
is full.
2. Make sure that the coffee bins have been properly
filled according to the Basic Operating Instructions in
the use and care manual.
3. Check the regulator to make sure it is properly
adjusted. Air in the system during initial operation can
cause the initial adjustment to be incorrect.
4. Make sure that water flows through the pressure
regulator in the right direction.
5. Repeat the above test.
6. If the appliance still does not work, contact an
authorized Dacor
®
service company. If you are
unable to locate a Dacor Service company, please
contact Dacor at (800) 793-0093, or visit us on the
web at www.Dacor.com. Do not attempt to repair
the appliance yourself. Dacor is not responsible for
service required to correct a faulty installation.
I
f
y
ou
n
eed to
r
emove the
c
offee
s
ystem
f
rom the
c
abInet
Should the coffee system need to be removed from its
location:
• Disconnect the power plug from the power receptacle.
• Press the respective locking tabs on the glides and
remove the appliance, supporting it from below.
CAUTION
Pour only roasted, unflavored coffee into the coffee bean
container. Any other kind of coffee, e.g. coffee which has
already been ground, will damage the grinder.