Dacia Solenza 2004, Руководство по ремонту

Страница: 592 / 891

82
ACCOUSTIC WARNING - ANTI STARTING
82 - 49
Diagnostic – General
THE PROCEDURE OF
KEYS ASSIGNATION
IMPORTANT
:
if not all keys are available it
will be necessary to subsequently perform the
assignation procedure with all the keys.
Ente r in dialogue with syste m “A nti-
starting”
.
In menu
”Control menu”
,
“Specific
control”
, validate line
“SC028: Key program-
ming”.
Tester is displaying: “Take off the key from
anti-theft contact”.
Tester is displaying “Enter the after-sale
code” .
With contact set off, enter the after-sale se-
cret code (12 hexadecimal characters) and vali-
date it.
Tester is displaying
“Attention. Not pre-
sented keys will be not active. Re -launch
the procedure in order to re-assign them”
:
the programming is under way.
Tester is displaying:
“Insert key in anti-
theft contact and set the contact on, then
validate”
: set the contact on using a vehicle key
or a new key.
Tester is displaying:
“No of programmed
keys 1” and “ take off the key from anti-
theft contact, then validate”
.
Tester is proposing: “Do you wish to pro-
gram a new key ?”.
In order to assign additional keys, set the con-
tact on few seconds using the vehicle’s others
keys that must be assigned (maximum four), then
validate.
Tester is displaying: “2, 3, 4 programmed
keys” and “ take off the key from anti-theft
contact”.
ATTENT ION: these ones must be the
vehicle’s old keys or new not coded keys.
Tester is displaying: “ Data entry in memory”,
Cockpit Central Unit is coded and the keys are
assigned.
This message will be displayed for few
seconds, then you may come out from the re-
assignation procedure
ATTENTION : the maximum admissible
interval between each operation is of 5 min-
utes otherwise the procedure is canceled.
Tester is displaying in this situation the
me ssa ge :
“Pe r for ming conditions not
ac c omplishe d”
. T his me ssa ge is a lso
displayed in case of dialogue loss with the
Cockpit Central Unit or in case of battery
supplying cutting off.
SPECIAL SITUATIONS
If tester is displaying:
“Cockpit Central Unit is empty. Launch
the C ockpit Central Unit programming
procedure”
, then the Cockpit Central Unit is
not used. It is impossible to assign keys to a
not coded Cockpit Central Unit.
“Per forming conditions not accom-
plished
”, the entere d code is not correct;
check and then start again the code entering
procedure.
If the key does correspond to the Cockpit
Central Unit of that vehicle, the tester is dis-
playing
“Interrupted procedure: attention,
the keys assigned to the vehicle are the
ones that have been assigned before pro-
cedure starting. The pr esented keys be-
fore procedure interruption are not any-
more empty and can be only assigned to
this vehicle”
assigned.
vnx.su