Da-Lite Polacoat Da-Plex Semi-Rigid, Инструкция

Страница: 5 / 12

5
Step 3
Step 4
#10 Screw
4" Trim
Piece
T-track
Installation (continued)
3. While the screen is resting, the T-tracks can be installed into
the wall opening. Measure 2½” from the side of your wall
opening to locate the end of the first T-track piece
(See Figure 1). Using one of the 4” pieces of trim, snap the
trim into place on one end of the T-track, place the T-track in
the opening and slide until the lower portion of the trim is
against the wall. Secure that end of the track with a #10 screw
in the hole closest to the end (See Figure 2).
NOTE:
Most screen units will have one piece of T-track for the
side openings and two pieces each for the top and bottom
wall openings. Larger sized units (above 14’ wide) may have
three pieces of T-track each for the top and bottom openings.
4. Using the other 4” piece of trim as a guide, secure the
opposite end of the T-track section on the end hole with a #10
screw. Once both ends are attached, slide the 4” trim pieces
along the track to align the other positions and attach a #10
screw into the hole openings until completed (See Figure 2).
NOTE: Sliding the trim along the T-track will maintain the
proper alignment when attaching the T-track to the wall. This
alignment is necessary to allow the trim to snap on easily at
the end of the screen installation. Ensure the opening is level
on all four sides. If the opening is not level, the T-track will
need to be shimmed in order to ensure the screen trim is
level once attached to the T-track.
5. Repeat Steps 3 and 4 until all T-track sections have been
secured to the wall opening (See Figure 3). For top and
bottom sections, use 4” piece of trim to overlap at the seams
as a guide to ensure that both T-track pieces are flush with
each other in the wall opening.
Figure 2
Figure 3