D-Link DXS-3600 Series, Руководство по установке оборудования

Страница: 16 / 55

DXS-3600 Series 10GbE Layer 2/3 Switch Hardware Installation Guide
16
normally used for a connection that spans greater distances. The maximum distance that the copper wiring connection
can reach is 100 meters. Fiber optic connections can span over several kilometers.
The figure below illustrates how to properly insert SFP+ transceivers into the switch’s SFP+ ports.
Figure 2-4 Inserting SFP transceivers into the Switch’s SFP ports
The SFP+ ports also support other transceiver form factors like
SFP
,
SFP+
, and
WDM
transceivers. A complete list of
SFP/SFP+/WDM transceivers, compatible with this switch, can be found in the “ Appendix A - Technical
Specifications“” section in Appendix A, at the end of this document.
Installing Power Modules into the Power Module Ports
The power module slots, located on the rear panel of this switch, support two types of power supply modules.
AC Power Supply Module:
 DXS-3600-PWR-FB : A 300W AC power supply tray with front-to-back airflow.
 DXS-3600-PWR-BF : A 300W AC power supply tray with back-to-front airflow.
DC Power Supply Module:
 DXS-3600-PWRDC-FB : A 300W DC power supply tray with front-to-back airflow.
NOTE: The Power Modules all support a specific airflow direction. This air-flow direction must be
the
same
as the Fan Module installed.
By default
the airflow direction of the Power Module and
Fan Module installed is front-to-back .
Installing an AC Power Module
Connect the one end of the AC power cord supplied to the AC power connector and the other end into a properly
grounded electrical outlet. The switch will automatically adjust the AC power setting to adapt to any voltage supply in
the range from 100~240VAC at 50~60Hz.