DSL-1500G++ User Manual
-
64
-
4.
Before preceeding any advanced configuration, set 4WActive Line and Active Line as
True
.
5.
If to choose 4-wire mode, select
true
in the 4Wire Enable drop-down list, and then
click on
to submit your setting.
6.
Similarly, if to choose 2-wire mode, select
false
in the 4Wire Enable drop-down list,
and then click on
to submit your setting.
7.
If to set DSL-1500G++ as CO or CPE, select
CO or CPE in
the Mode drop-down list
and then
click on
to submit your setting.
8.
Moreover, other attributes that are also available for editing, click on
to update
the advanced configuration, or
Reset
to revert back to the default advanced
configuration settings. Click on the
Return to basic attribute
list to return to the
Shdsl
Port Configuration
page.
Note: 1.
if you want set the device as 4-wire mode, in the Bite Rate mode drop-down list,
only
fixed
mode is valid value and selectable.
2.
If to configure the transmission rate for CO and CPE, set as fixed mode already,
users should unplug the RJ-11 loop cable first and then configure the
transmission rate through Fixed Bit Rate drop-down list. After that, replug the loop
cable into the device.
3.
If to switch 2/4 wire mode, the RJ-11 loop cable should be unplug first. Plug the
loop cable again after your configuration is completed.
4.
The DSL-1500G++, featured with CPE and 2-wire mode, is recommended to
set Bite Rate Mode as adaptive and Fixed Bit Rate as 2312 kbps so that the real
transmission rate could be decided by the CO side.
5.
If the CO and CPE side are set as fixed mode and have different Rate, the two
devices will be idle and the loop LED will be off. To reactivate the devices, users
should unplug the loops cable first and then set the same rate for CO and CPE
side. After that, set Active Line/4WActive Line as
true
and press
to
