DSL-1500G++ User Manual
-
60
-
2. Configure the trigger as follows:
a. Transport Type; select a transport type from the drop-down list, depending on
whether you are adding a trigger for a TCP or a UDP application.
b. Port Number Start; type the start of the trigger port range that the primary session
uses.
c. Port Number End; type the end of the trigger port range that the primary session uses.
d. Allow Multiple Hosts; select allow if you want a secondary session to be initiated
to/from different remote hosts. Select block if you want a secondary session to be
initiated only to/from the same remote host.
e. Max Activity Interval; type the maximum interval time (in milliseconds) between the
use of secondary port sessions.
f. Enable Session Chaining; select Allow or Block depending on whether you want to
allow multi-level TCP session chaining.
g. Enable UDP Session Chaining; select Allow or Block depending on whether you want
to allow multi-level UDP and TCP session chaining. You must set Enable Session
Chaining to Allow if you want this to work.
h. Binary Address Replacement; select Allow or Block depending on whether you want
to use binary address replacement on an existing trigger.
i. Address Translation Type; specify what type of address replacement is set on a trigger.
You must set Binary Address Replacement to Allow if you want this to work.
3. Once you have configured the trigger, click on
. The Firewall Trigger
Configuration page is displayed, containing details of the trigger that you have just
configured.
4. Each trigger displayed in the Firewall Trigger Configuration page has a Delete hyperlink
assigned to it. To delete a trigger, click on this link, then at the confirmation page, click
on the Delete button.
