DHCP, DNS and Time
Dlink DRO-220i User Guide
14
2
Interfaces
The router provides the following interface ports:
LAN Port -
The router has one dedicated 10/100 Ethernet RJ-45 LAN port.
WAN Ports -
The router has four WAN ports.
o
WAN1 –
V.35 can be connected to 2 Mbps Leased modem.
o
WAN2 –
It’s ISDN S/T port is connected to either a dial up line or a dedicated
leased line. It also supports bandwidth on demand (BOD), Auto Hang-up, Dial
on Demand (DOD). It uses MLPPP to aggregate two channels to get 128
Kbps.
o
WAN3 –
This port can be optionally reconfigured to operate as DMZ port.
The WAN3 interface can be used to connect to the Internet using any
broadband modem. The administrator has the following three choices for
WAN connectivity:
Static
:
The administrator can configure a Static IP Address assigned by the
ISP to connect to the broadband network.
Dynamic
:
The ISP assigns an IP Address dynamically using DHCP Protocol.
PPPoE
(Point to Point link over Ethernet): This option is the most common
mode of WAN connectivity. Here the ISP assigns an IP Address dynamically
through PPPoE Protocol.
The following sections explain these interfaces and their configuration in detail.
2.1
LAN Interface
The user systems can be connected to the LAN Interface. And the administrator can
configure the router using HTTPS to this LAN Interface IP Address (i.e
https://RouterLANIP
). If the administrator uses
http://RouterLANIP
by mistake, the
router will automatically redirect the Web Browser to use https.
L
Note:
Default LAN Interface IP Address is 192.168.100.254.
Select
Interface
→
LAN
to configure
LAN
Settings
as explained below.
LAN Settings
IP Address
Enter the IP address of the LAN interface.
Subnet Mask
Enter the subnet mask of the LAN interface.
Forgot LAN IP ?
Web UI
