DIR-853
AC1300 MU-MIMO Wi-Fi Gigabit Router
with 3G/LTE Support and USB Port 3.0
User Manual
Configuring via Web-based Interface
You can specify the following parameters:
Parameter
Description
General Settings
Enable rule
Move the switch to the right to enable the rule.
Move the switch to the left to disable the rule.
Name
A name for the rule for easier identification. You can specify any
name.
Action
Select an action for the rule.
Allow
: Allows packet transmission in accordance with the criteria
specified by the rule.
Deny
: Denies packet transmission in accordance with the criteria
specified by the rule.
Protocol
A protocol for network packet transmission. Select a value from the
drop-down list.
IP version
An IP version to which the rule will be applied. Select the relevant
value from the drop-down list.
Source IP address
Set as
Select the needed value from the drop-down list.
Start IPv4 address /
Start IPv6 address
The source host start IPv4 or IPv6 address.
If it is necessary to specify a single address, leave the
End IPv4
address / End IPv6 address
field blank.
You can choose a device connected to the router's LAN at the
moment. To do this, select the relevant IPv4 or IPv6 address from the
drop-down list (the field will be filled in automatically).
End IPv4 address /
End IPv6 address
The source host end IPv4 or IPv6 address.
Subnet IPv4 address /
Subnet IPv6 address
The source subnet IPv4 or IPv6 address. The field is displayed when
the
Subnet
value is selected from the
Set as
drop-down list.
Destination IP address
Set as
Select the needed value from the drop-down list.
Page
191
of 228