DIR-806A
Wireless AC750 Dual Band Router
User Manual
Figure 67. The page for creating a new
PPPoE
connection. The
Miscellaneous
section.
Parameter
Description
Miscellaneous
NAT
If the switch is moved to the right, the network address translation
function is enabled. Do not disable the function unless your ISP
requires this.
Firewall
If the switch is moved to the right, protection against external
connections for the LAN devices is enabled (for example, against
attempts to get information about the LAN devices or to hack a
device from the LAN). For security reasons, it is recommended not
to disable this function.
RIP
Move the switch to the right to allow using RIP for this connection.
Ping
If the switch is moved to the right, the router responds to ping
requests from the external network through this connection. For
security reasons, it is recommended to disable this function.
Isolate connection
If the switch is moved to the right, the router uses an alternate
routing table for this connection. Enable this function only when
your ISP requires this.
When all needed settings are configured, click the
APPLY
button.
After clicking the button, the window for creating an additional connection opens.
If your ISP offers access to local services (e.g. audio and video resources), click the
CREATE
button. On the page displayed, specify the parameters for the connection of the Dynamic IPv4 or
Static IPv4 type and click the
APPLY
button. Click the
BACK
button to specify other settings for
the connection of the PPPoE type.
If you do not need to create an additional connection, click the
SKIP
button. In this case, the
Connections Setup / WAN
page opens.
Page
78
of 180
