38
D-Link DCS-5029L User Manual
38
Section 4 - Configuration
HTTP Port:
Access Name for
Stream 1~3:
HTTPS Port:
Authentication:
RTSP Port:
Access Name for
Stream 1~3:
Enable CoS:
Enable QoS:
Enable IPV6:
Enable Multicast
for stream:
You may configure a second HTTP port that will allow you to connect
to the camera using a standard Web browser. The port can be set to a
number other than the default TCP port of 80. A corresponding port
must be opened on the router. For example, if the port is changed
to 1010, users must type
http://192.168.0.100:1010
instead of
http://192.168.0.100
.
The default name is video#.mjpg, where # is the number of the
stream.
You may use a PC with a secure browser to connect to the HTTPS
port of the camera. The default port number is 443.
Click the drop-down menu to enable authentication of RTSP (Real
Time Streaming Protocol).
The port number that you use for RTSP streaming to mobile devices,
such as mobile phones or PDAs. The default port number is 554.
You may specify the address of a particular stream. For instance,
live1.sdp can be accessed at rtsp://x.x.x.x/video1.sdp where the
x.x.x.x represents the ip address of your camera.
Check to enable CoS (Class of Service), which implements assignment
of priority using a best-effort policy without making any bandwidth
reservations.
Check to enable QoS (Quality of Service), which allows you to specify
a traffic priority policy to ensure a consistent Quality of Service
during busy periods. If the network camera is connected to a router
that itself implements QoS, the router’s settings will override the
QoS settings of the camera.
Enable the IPV6 setting to use the IPV6 protocol. Enabling the option
allows you to manually set up the IP address, specify an optional IP
address, specify an optional router and an optional primary DNS.
The DCS-5029L allows you to multicast each of the available streams
using a group address. You can specify the TTL value for each stream.
Enter the port and TTL settings you wish to use if you do not want to
use the default settings.
Click
Save Settings
.
